Call Us

+1 208-495-0555

Address

16141 N. 20th St. Nampa, ID

Install Press Conve...
 
Notifications
Clear all

[Closed] Install Press Conveyors

1 Posts
1 Users
0 Likes
135 Views
Michael Vernor
(@mvernor)
Noble Member Admin
Joined: 2 years ago
Posts: 42
Topic starter  
  • Install the spring-loaded side of the press conveyor. Use the 3X M10 bolts to hold it in place, do not tighten down fully. Note the roller side of the conveyor should be facing towards the center of the system.

  • Install the pinned side of the press conveyor on the press platen. Note the chain side should be facing towards the outside of the press. Use 3X M10 bolts to secure to the press platen.
  • NOTE: There are left and right hand versions of the press conveyor. Ensure the correct side is being installed.

  • Install the underside bolts on the attachment plate between the two press conveyor sections. Do not fully tighten.

  • Set the spring-loaded side of the press conveyor to the following dimensions: XX from edge of plate to front edge of the press platen. Fully tighten the bolts.
  • Fully tighten the underside attachment plate bolts.